Strawberry Server
User and Hardware Manual
39
1. Remove the two screws connecting the drive tray to the carrier.
2. Remove the tray from the carrier.
3. Place the hard drive tray on a flat, stable surface such as a desk, table, or work bench.
4. Slide the hard drive into the tray with the printed circuit board side facing down.
5. Carefully align the mounting holes in the hard drive and the tray. Make sure the bottom of
the hard drive and bottom of the hard drive tray are flush.
6. Secure the hard drive using all six screws.
7. Replace the drive tray into the chassis. Make sure to close the drive tray using the drive
tray handle.
Replacing the Power Supply
CAUTION Power must be removed on the server is not removed to the server by just
depressing the Power switch. You must remove BOTH AC power cords before
replacing the Power Supplies. Failure to do so could cause personal injury and damage
to the server.
ATTENTION L'alimentation doit être retiré sur le serveur n'est pas supprimé sur le
serveur d'un peu déprimant l'interrupteur d'alimentation. Vous devez supprimer les deux
cordons d'alimentation avant de remplacer des blocs d'alimentation. Ne pas le faire
pourrait causer des blessures et des dommages sur le serveur.
