USER MANUAL
15
Place the point of the bit in the indentation and start drilling. Use a cutting
lubricant when drilling metals the exceptions are iron and brass which
should be drilled dry.
CATION:
- Pressing excessively on the tool will not speed up the drilling. In fact,
this excessive pressure will only serve to damage the tip of your bit,
decrease the tool performance and shorten the service life of the tool.
- There is a treamendous force exerted on the tool/bet at the time of hole
break through. Hold the tool firmly and exert care when the bit begins to
break through the workpiece.
- A stuck bit can be removed simply by setting the reversing switch to
reverse rotation in order to back out. However, the tool may back out
abruptly if you do not hold it firmly. Always secure small workpieces in a
vise or similar holddown device.
- If the tool is operated continuously until the battery cartridge has
discharged, allow the tool to rest for 15 minutes before proceeding with
a fresh battery.
CHRGING
3
2
1
1.Pilot Lamp
2.Battery Negative Pole
3.Charger Negative Pole
