13
6. Demo mode
The built-in
Demo
mode is available to demonstrate operation of the device.
6.1.
Disconnect the measuring cable from the device and turn the device off.
6.2.
To start
Demo
mode, press and hold the On/Off key
for about 1 sec. until the
second beep sounds and “
Demo
” indication appears on the screen.
6.3.
During
Demo
cycle the operating sequence of the device is shown on the screen.
Press On/Off key
to pause the simulation; press On/Off key
again to
resume.
6.4.
When
Demo
cycle is completed, it is repeated automatically until interrupted by the
operator.
6.5.
To exit
Demo
mode press and hold the On/Off key
for about 1 sec. until a beep
sounds.
Note:
If measuring cable is inserted into the device receptacle during
Demo
cycle,
RomiApex™ A-15
exits
Demo
mode and switches automatically to regular operation
mode.
7. Maintenance, Cleaning and Sterilization
7.1.
General
The device does not contain user serviceable parts. The service and repair should be
provided by factory trained service personnel only.
All objects that were in contact with potentially infectious agents should be cleaned after
each use
:
Lip clip, file clip
and
touch probe
should be disinfected and sterilized by autoclaving
before the first use and between treatments. Please follow
“Disinfection and sterilization
procedure” described in next section.
Measuring cable
,
the device and its cradle
should be cleaned using tissue or soft
cloth impregnated with aldehyde free disinfecting and detergent solution (a bactericidal
and fungicidal).
The measuring cable should not be autoclaved.
Use of agents other than specified above may cause damage to the
equipment and its accessories.
