Step 2 - Wall Profiles
1. Take one of the Wall Profiles and position it 12mm in from the outside of the tray.
2. Ensure the Wall Profile is completely vertical using a Spirit Level then using a pencil mark the wall through
the slots.
• Make certain the wall profile is completely vertical using a Spirit Level ( the bubble should be in the
centre of the two lines).
3. Follow the same procedures for the other Wall Profile.
4. Drill the walls using a 7mm Masonry Drill Bit (not supplied) and fit the Wall Plugs.
5. Remove any debris and apply a bead of sealant the width of the Wall Profiles where they meet the top of
the tray / wetroom floor and the tiled walls.
6. Screw fix both Wall Profiles to the walls using the 40mm Cap Head screws (supplied) ensuring they are
kept completely vertical and are 12mm in from the outside of the tray.
7. Apply a bead of sealant to the inside of the Wall Profiles at the bottom where they meet the top of the tray /
wetroom floor.
• IMPORTANT: Failure to comply with stages 5 and 7 may cause serious water damage and is not covered
under the terms of the guarantee.
①
⑤
⑦
12mm
