Step 6 - Sealing and Seals
1. Seal all the Wall Profile Covers to the tiled wall vertically both inside and outside.
• IMPORTANT: Ensure that the Covers are placed between the Wall Profiles and Tiled Walls.
2. Seal the outside of the Enclosure fully horizontally from wall to wall on the outside only.
• IMPORTANT: Do not seal on the inside as this may cause serious water damage and is not covered under
the terms of the guarantee.
3. On the prefitted Bottom Rail Panel Joints and Door Joints carefully add a small bead of silicone to the gaps
between them and the Bottom Rails, add a bead of silicone to the top of the Door Joints and Panel Glass.
4. Fit the Vertical Panel Seal to the edge of the Plain Panel Glass and down onto the Door Joint, trim the top.
5. Fit the Vertical Door Seal onto the edge of the Door Glass at the hinge side making sure the cut outs fit
around the hinges. Carefully trim the bottom so it is level with the top of the Door Joint.
6. Take a measurement from the Hinged Panel Glass to the end of the Door (at the Handle Side).
7. Take note that the Bottom Seal is rebated at each end, the end that will go at the Hinged Panel side is the
end to cut. Cut the Bottom Seal to the length taken previously and fully fit the Seal onto the bottom of the
Door ensuring that it butts up to the Hinged Panel glass.
• IMPORTANT: ENSURE the Deflector on the Bottom Seal is facing inwards towards the shower.
8. Fit the Branding Clip to the top of one of the Panels with a small amount of silicone.
• IMPORTANT: Failure to follow stages 1,2 and 3 may result in serious water damage and is not covered
under the terms of the guarantee.
• Please allow 24 hours for the sealant to fully cure before using the enclosure.
③
③
Prefitted
Joint
①
⑦
②
⑧
⑤
Rebate
④
