Manual No. 4801-5156 Rev 4-08
RollSeal SC-325 & SC-650
Page 21 of 44
10. Controller Installation and Setup
10.1 Tools
Required
Small screwdriver
Standard Screwdriver Wire
strippers
10.2 Installation
Instructions
1.
Unpack system, and check that all components are present.
1
RollSeal Smart Controller
1 Installation
Kit
1 Manual
2.
Hang the controller with four screws at the desired location.
3.
Make sure all power supplies are disconnected before breaking any wires, or reaching into the
controller enclosure.
4.
Determine the required Powering Voltage whether 115 VAC or 230 VAC.
5.
If the desired power supply voltage is different from the factory preset/prewired voltage, the
appropriate version Brake Rectifer must be ordered separately, field-installed on the RS Door,
and the SC controller switch & jumper settings changed accordingly. The SC-325 controllers
are factory preset to 115 VAC and the RS-500 doors factory prewired to require a 115 VAC
power supply. The SC-650 controllers are factory preset to 230 VAC and the RS-600 doors
factory prewired to require a 230 VAC power supply. The SC-325/SC-650 controllers and
RS-500/600 doors can be field upgraded to accommodate either 115 VAC or 230 VAC power
supply. Refer to
Section 12.5
for the SC controller power wiring, switch setting, and jumper
setting and
Section 12.6
for the Motor Brake Rectifier part numbers and wiring information.
6.
Connect power.
7.
Turn the controller on.
8.
Set the Open and Closed Speed and Limits, the Acceleration and Deceleration Ranges, Close
Time Delay and Switch positions as discussed in
Section 5
of this manual.
W A R N I N G !
Only a qualified electrician should install and/or
service this equipment.
Failure to observe precautions could result in
equipment damage, severe bodily injury, or loss of life.
W A R N I N G !
Dangerous High Voltages!
Allow Approximately 5 Minutes For The Controller To
Power-Down Before Changing Switch Settings, Jumper
Placement, Or Wiring.