9
Skyline & R-Series
Cassette 80 Fabrication
Step 5: Assemble Headrail and assembled shade
5a. Lay Cassette on table or flat surface. Insert one bracket by aligning bracket into grooves on
inside top of the headrail. Push bracket all the way in. (be careful not to bend bracket if using a
mallet or hammer to tap brackets in) If desired, use screws to hold brackets in place
5b. Insert clutch and idler end of tube onto the bracket. (see note for R-Series)
5c. Attach End Caps (if desired)
5a.
5a.
Skyline
For Skyline, insert idler side first. Push into bracket, and slip
clutch side down until the hooks engage in the holes in the
bracket and lock into place.
5b.
R-Series
5b.
5b.
5b.
5a.
Gently tap
bracket into
headrail
Push tip of
pin end into
hole in the
center of the
Skyline
bracket
Slide the
center of the
end plug into
the tab on
the R-Series
bracket
Engage the
hooks of the
Skyline clutch
into the slots
in the
bracket and
secure in
place
Slide the hole in
the center of the
clutch into the
tab on the R-
Series Bracket
When fabricating R-Series,
you must insert one bracket
and insert clutch or pin end,
and then simultaneously
insert other bracket into
the opposite end.
Lay plastic across cassette before
laying in tube with fabric. After
installing shade, tie around the top
of cassette to prevent shade from
falling during shipment to
customer.
Cassette 80
