Roland VS8F-3, Owner'S Manual

Page: 13 / 36

13
If you own two (or more) VS series units and one VS8F-3 board
For the first VS series unit, you must install the VS8F-3 in
the first slot (p. 10) when authorizing.
This VS8F-3 will become the “Key Card” when
authorization is completed.
When authorization is performed, data describing the
combination of VS plug-in programs and Key Card
(VS8F-3) is written to the hard disk during installation.
If you move the Key Card from the first VS series unit to
another VS series unit, the same VS plug-in programs
used on the first unit can then be installed using the
already-authorized SETUP DISC. In other words, as long
as the Key Card is installed, you can install its VS plug-in
programs from the SETUP DISC and use them.
However, since there is only one Key Card, you will not be able to use these VS plug-in programs as authorized plug-ins on two or more
VS series units at the same time.
Please place the Key Card sticker on the VS8F-3 that is designated as the Key Card (To learn about the Key Card,
please refer p. 9).
VS series
(#1)
VS8F-3 SETUP DISC
(not authorized yet)
before
the authorization
Install
in the first slot
VS series
(#1)
VS8F-3
(Key Card)
SETUP DISC
(Authorized)
Authorized
Key Card
installed
Authorize
information
OK
VS series
(#2)
VS8F-3
(Key Card)
SETUP DISC
(Authorized)
Authorized
Key Card
installed
Authorized
information
OK
VS series
(#1)
VS8F-3 (Key Card)
installs to #2
SETUP DISC
(Authorized)
VS series
(#2)
Key Card
installed
Authorize
information
Key Card is not
found
OK
cannot use
NG!