Roland PNC-1600, User Manual

Page: 43 / 47

41
Index ( Display Menu )
Display Menu Explanation Remark
Factory
default
See page
Baudrate Sets baud rate. 9600 2 9
BufferClear
Deletes any data in the buffer. The previous batch of data is deleted when
27, 28
new data is sent.
Calibrate Adjusts actual length when cutting. 0 2 7
CoodinatteDisplay
The current position of the tool carriage is
24
displayed using coordinate values.
CutTest
Used to check set tool conditions by means of Peel off first the circle, then the square.
15, 16, 17 ,
2 3
actual cutting. Conditions are appropriate if the cutter has left
only a light trail on the base paper.
DataBits
Sets data length. 8
2 9
Default
Resets settings to their factory default values.
2 5
Force
Sets cutting force.
Select a value from 10 g to 350 g (in
increments 120 g 8, 16, 17, 23
of 10 g)
Handsheke Sets handshaking. Hardwire 2 9
Instruc
Sets the instruction system.
When set to "Auto," the mode in use is
displayed
mode 1
2 8
after automatic determination has been
completed.
I/O
Selects the type of interface connection.Selects
When the I/O interface is set to "Auto," the
type Auto
8, 9, 28
the type of interface connection. of interface connection detected is displayed.
Load Calls up settings stored in memory. USER1—4 2 6
Offset
Sets the blade offset value.
This sets the offset for the blade at a value
from 0
10 8, 16, 17, 18,
2 3
to 40 (0 mm to 1.000 mm). ( 0.25 mm)
Origin
Moves the origin ( 0, 0 ) to a desired location Relocating the origin allows the sheet to be cut
( 0, 0 )
2 7
within the cutting area. wherever desired.
Parity Sets parity. None 2 9
Plotocol
Selects the settings for baud rate, data length,
stop
Displayed only when the I/O interface is set to
bits, parity, and handshaking. "Serial."
Replot Performs cutting again using the same dates 2 8
Save
Stores the current settings in memory. Four sets of settings can be stored in memory. USER1— 4
2 5
Select Selects the number of the tool to be used. 2 6
SheetSize
Sets the sheet size (cutting area). Sets the lower left corner as LL. LL: Min.value
2 3
Sets the upper right corner as UR.
UR:
Max.value
Smoothing
Used to cut smooth curves. Cannot be set to "ON " when weight is set to
ON 2 4
"Heavy."
Speed
Sets the cutting speed. When weight is set to "Heavy," the maximum
30 cm/s
16, 17, 23
speed is 40 cm/s.
StopBit
Sets the number of stop bits.
Operation is normal even when there is one
stop 1 2 9
bit.
Tool
Selects the tool, and chooses the cutter offset,
speed, and pen force settings.
Tool up / down
Moves the tool up or down.
2 4
TopMenu Returns the display to the top menu.
Unit
Sets the coordinate value shown on the
display.
1 mm = 40 steps Step 2 5