Roland Metaza MPX-90, User Manual

Page: 40 / 120

38
3-2 Getting Ready
Chapter 3 Making Prints
If you’re performing printing with head cap used, this completes loading of the material.
If you’re performing printing with no head cap used, then go on to the following steps.
The procedure from this point on is for when you’re not using the head cap.

Press the Power/Movement but-
ton.
The head moves and stops at the position
where the tip of the head cap rides on the
surface of the material.

Loosen the knob.
Rotate the knob counterclockwise once.
Then you can move the stopper.
When material is too large to be placed within the table
Place the material in a way that the
center of the printing area comes to
the center of the scale on the table.
If the material tilts, place a support
in order to keep the material hori-
zontal.
Center
Line
Center Line
Material Center of the
material
Adhesive
sheet
Stopper
Knob