Roland Kiwitechnics KIWI-SJX, Manual

Page: 39 / 89

39
Setting up with External Devices
Midi Notes
Midi Through should be used if
multiple units are being used on the
midi chain to reduce delays. While
every effort has been made to make
the midi as fast as is possible within
the KiwiTechnics KiwiSJX Upgrade
there will always be small delays
between the midi input and midi
output. The way the JX-10/MKS70
was designed the midi is input to the
cpu board, then transmitted to one
of the voice board cpus internally
and then sent out the midi out. While
the communication between the
internal boards is at a high speed
this still creates extra delays as the
commands need to be interpreted
twice which cannot be done until a
full command arrives at each cpu.
Full midi command details are at the
end of the manual.
Hold Pedal
Any pedal that shorts the tip to
ground when pressed or open can
be used. You can reverse the hold
pedal sensing by using Global
Parameter G4B3T6. The control
made by this pedal can be
assigned using the matrix. This
input is only available in the JX-10.
Switch Pedal
Any pedal that shorts the tip to
ground when pressed or open can
be used. You can reverse the
Switch Pedal sensing by using
Global Parameter G4B3T7. The
control made by this pedal can be
assigned using the matrix. This
input is only available in the JX-10.
www.kiwitechnics.com JX-SJX Upgrade User Manual v100