Roland EGX-30A, User Manual

Page: 42 / 52

40
Chapter 4 Appendix
4-1 Maintenance
Cleaning
WARNING Never use a pneumatic blower.
This machine is not compatible with a pneumatic blower. Cutting waste may get
inside the machine and cause fire or electrical shock.
WARNING
Never use a solvent such as gasoline, alcohol, or thinner to perform cleaning.
Doing so may cause fire.
WARNING
Disconnect the power cord before performing cleaning or maintenance.
Attempting such operations while the machine is connected to a power source may
result in injury or electrical shock.
WARNING
When using a vacuum cleaner to take up cutting waste, exercise caution to prevent
fire or dust explosion.
Taking up fine cuttings using an ordinary vacuum cleaner may cause danger of
fire or explosion. Check with the manufacturer of the vacuum cleaner. When the
safety of use cannot be determined, clean using a brush or the like, without using
the vacuum cleaner.
CAUTION Caution: high temperatures.
The cutting tool and spindle motor become hot. Exercise caution to avoid fire or
burns.
CAUTION
When performing maintenance, be sure to keep the tool detached.
Contact with the blade may cause injury.

This machine is a precision device. Carry out daily care and maintenance.
 Carefully clean away cutting waste. Operating the machine with a large amount of cutting waste present may cause
malfunction.

Never apply silicone substances (oil, grease, spray, etc.) to the machine. Doing so may cause poor switch contact.

Never apply lubrication.
Cleaning around the table
After operation, use a brush or the like to clean away any buildup of cutting waste around the table or on the machine.