Chapter 3 Getting Ready for and Performing Cutting
3-2 Before Starting to Cut
Loading the Material
If the material is not secured correctly, it may not be cut as intended.
Some examples of material loading are shown below. Refer to these to use the appropriate method for the material at hand
to secure it in place.
* Material thickness -- Up to 5 mm (3/16 in.)
* Be sure that the tool carriage is at the VIEW position ( inner right-hand side ) before loading material.
Adhesive sheet for
securing material
Double-sided tape
Bottom of the material
Using the included adhesive sheet...
Using commercially available double-sided tape...
Material
27
Summary of Contents for EGX-30A
