Roland EGX-30A, User Manual

Page: 30 / 52

Chapter 3 Getting Ready for and Performing Cutting
3-3 Installing a Tool
The steps for installing a tool are shown below. Follow these steps to install the appropriate tool for the task.
For Engraving (Character Cutter)
* Use SELECT key to choose "ENGRAVER" as the mode.
When installing a cutter for engraving, make sure the tip of the cutter protrudes beyond the surface of the material by an
amount equal to the depth of engraving to be performed.
Move the tool carriage to a position over the material surface, then install the cutter.
Procedure

Install the depth regulator nose as
shown in the figure.

Loosen the tool mounting screw and
insert the depth regulator nose in the
tool carriage.
1. Line up the
protrusion with
the groove on the
front, and fit it in
the groove.
3. Retighten the tool
mounting screw to secure
the nose in place.
2. Rotate in the direc-
tion of the arrow.
The spanner included with the unit is 3 mm (1/8 in.)
thick, and can be used as to check the width of the
space.
Screw part
3 mm (1/8 in.)
Adjust the screw so to make this
space 3 mm (1/8 in.).
3 mm (1/8 in.)
For checking the space of the screw part
28