Roland EGX-30A, User Manual

Page: 39 / 52

Chapter 3 Getting Ready for and Performing Cutting
3-5 Sending Cutting Data
Sending Cutting Data
Cutting is performed when data is sent from the computer (software application).
Refer to the manual for the software and drivers you are using for an explanation of how to output cutting data.
Changes That Can Be Made While Cutting
Pausing Operation
PAUSE
Pressing the PAUSE/VIEW key causes operation to pause, even when cutting is in progress.
Press the PAUSE/VIEW key a second time to continue cutting.
ESCAPE
Holding down the PAUSE/VIEW key for one second or longer causes the tool carriage to move to the VIEW position and
stop.
Press the PAUSE/VIEW key a second time to continue cutting.
STOP
Press the PAUSE/VIEW key to pause operation.
Stop sending data from the computer, then switch off the power to the EGX-30A.
To restart the cutting operation from the beginning, switch the power back on, and send the data from the computer again.
(The origin-point setting remains in memory even when the power is switched off.)
Spindle Speed
Changes the rpm knob on the control panel.
Cutting Speed
Changes the SPEED knob on the control panel.
37