Chapter 3 Getting Ready for and Performing Cutting
3-6 Ending Cutting Operations
Ending Cutting Operations
WARNING
Wash hands when finished.
Wash hands with water to remove any adhering cutting chips.
WARNING
Use a vacuum cleaner to remove cutting dust. Do not use any blower such as an
airbrush.
Otherwise, dust spread in the air may harm your health or damage the machine.
Procedure
Press the PAUSE/VIEW key to move the tool carriage to a position where the tool and
material can easily be removed.
Move the tool carriage to the inner-right area of the table, make sure operation is stopped,
then remove the material.
If the material is secured by an adhesive sheet or double-sided tape, peel the adhesive sheet off of the
table and store it in a location free from dust.
Remove the tool and put it away.
If the day's operations are finished, remove the cutter, depth regulator nose. Use a dry cloth to wipe away
any grime, cap the cutter, and put it away.
Switch off the power to the EGX-30A.
Close the software application and switch off the computer.
If engraving was performed, vacuum up any cuttings.
38
Summary of Contents for EGX-30A
