Panel Descriptions
Phones Jacks
Here you can connect stereo headphones.
The unit has two headphone jacks, two people can
also use headphones simultaneously.
Input Jack
If a digital audio player
or other audio playback
device is connected here,
you’ll be able to listen to
its playback through the
unit.
Use the controls of your
audio playback device to
adjust the volume.
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
* When connection cables with resistors are used, the volume level of equipment connected to the Input jack may be low. If this happens, use connection cables that do
not contain resistors.
Output Jacks
If you connect these jacks to
amplified speakers, the sound of
unit will be heard through them.
* Before turning off the power of
the unit, you must first turn off
the power of the devices that are
connected to the Output jacks.
DC In Jack
Connect the
included AC
adaptor here.
* Before making this connection,
you must make sure that the
[Power] switch is off.
Pedal Connector
Connect
the pedal
cord of the
dedicated stand to this
connector.
Rear side
Ground Terminal
Depending on the circumstances of a
particular setup, you may experience a
discomforting sensation, or perceive that
the surface feels gritty to the touch when
you touch this device. This is due to an
infinitesimal electrical charge, which is
absolutely harmless. However, if you are
concerned about this, connect the ground
terminal (see figure) with an external
ground. When the unit is grounded, a slight hum may occur, depending
on the particulars of your installation. If you are unsure of the connection
method, contact the nearest Roland Service Center, or an authorized
Roland distributor.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event
of lightning)
A Headphones 3D Ambience effect will
be applied, producing the sensation that
the sound is emanating from the piano
itself even when using headphones.
* The Headphones 3D Ambience effect applies only to
piano tones; it does not apply to other tones.
* You can also turn the Headphones 3D Ambience
effect off (p. 46).
* You can use the [Ambience] button to adjust the
Headphones 3D Ambience effect.
11
O
per
ation G
uide
Panel Descriptions
Bef
or
e
You P
la
y
Per
forming
Pr
ac
ticing
Con
venien
t F
unc
tions
A
ppendix
Func
tion M
ode
Summary of Contents for DP90e
Page 1: ......
Page 66: ...For EU Countries For China 66...
Page 68: ...5 1 0 0 0 3 6 7 8 2 0 1 5 1 0 0 0 3 6 7 8 2 0 2...
