11
About Placement
If using commercially available Cat5e Ethernet cables, attach the supplied REAC
connector covers to the connectors.
Attach the rubber feet when not rack mounting the unit.
Peel off the backing from the double-sided adhesive tape on the rubber feet and
attach the feet at the points indicated in the figure below.
928
* When turning the unit upside-down, get a bunch of newspapers or magazines, and place
them under the four corners or at both ends to prevent damage to the buttons and controls.
Also, you should try to orient the unit so no buttons or controls get damaged.
929
* When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to
fall or tip over.
Using the REAC Connector Covers
Attaching the Rubber Feet
Remove the REAC connector
covers if you are using REAC
cables with EtherCon type
connectors (SC-W100X or SC-
W100S).
Take care not to lose the REAC
connector covers removed at
this time.
bottom of the unit
S-4000-SP_e.book 11 ページ ２００６年８月２４日 木曜日 午前１０時３３分
