17
3D
ISO
N S U
ser M
an
ua
l
Hardware
FAQ
What if the filament is not properly discharged?
-
There are a few causes to prevent filaments from coming out well. One of the most common causes is when is clogged. When this happens, set the
extruder temperature higher than 240
℃
at [Utilities] > [Preheat Setting], and use [Preheat] function of display menu to melt the filaments accumu-
lated inside the nozzle, whereby the nozzle can be unclogged. (Reduce the extruder temperature again after use). If the method mentioned above
fails to solve the problem, use a hex wrench to unscrew the two bolts positioned at an upper surface of the extruder and the two bolts positioned
at a lower surface of the extruder, separate the two parts and check if filament scraps clog the nozzle hole. Next, unclog the nozzle hole using a long
unfolded clip or a smallest hex wrench provided at the time of purchase while the extruder is under a preheated state (do the separation work while
the power is turned off after preheat. Malfunction may occur if fan separation work is performed while the extruder is under the preheat state)
- Malfunction may also occur when the gear extruding the filament is not properly operated. If malfunction occurs, dismantle the extruder, and
remove the wastes accumulated on the gear using a brush such as tooth brush, then the problem can be solved.
- It is also important to set the extruder temperature according to material. If the extruder temperature is too high or too low, the material may hold
together, or may not be properly solved to prevent a smooth output. Be sure to check the proper temperature according to the used material.
Is multi colored printing available with 3DISON S at one time?
- You can get the multi colored output by using the function ‘Pause/Unpause’
Is it possible to adjust the printing speed and temperature on the machine while printing?
-
Yes. When pressing the OK button on the machine, you can adjust the printing speed and temperature while printing. Moreover, you
can control the printing such as temporary stop printing or cancellation.
What is the Auto-Leveling?
-
Auto-Leveling is the function that the horizontality of the printing bed is automatically adjusted. Thus, all users can easily use 3D
Printing without fine adjustment.
