12
3D
ISO
N S U
ser M
an
ua
l
Display Menu Introduction
There are 3 configuration items on the display menu; Print from SD, Preheat and Utilities.
1. Print from SD:
To load a file from SD Card.
2. Preheat:
To preheat the Hot-End(Nozzle) and Platform.
-
Right Tool : by setting On/Off you can start preheating of the right extruder.
3. Utilities :
It will lead to 12 different options for hardware. You do not want to change the settings without any specific
explanation because they are only for developers or aftersales service.
-
Monitor Mode : it shows current temperature of the extruder and printing status
.
-
Filament Loading : to put the filament into the extruder or pull it out of the extruder.
-
Preheat Settings : to set up temperature and the Extruder.
-
General Settings : To configure sound, LED color or etc.
●
Ditto Printing Off
●
Override GCTemp Off
●
Pause with Heat Off
●
Sound On/Off
●
Heat LEDs On/Off
●
LED Color : to change LED colors
●
Accelerate On/Off
●
Extruders
●
Extruder Hold On/Off
●
HBP Installed Yes/No
●
Tool Offset Sys New/Old
●
Check SD Reads Yes/No
●
P-Stop Control On/Off
How to use 3DISON S
