Rohm RKX-EVK-001, User Manual

Page: 36 / 56

36/55
© 2022 ROHM Co., Ltd. No. 64UG118E Rev.002
Feb.2022
User’s Guide
NOTE : Streaming and logging is automatically paused once the Register editor tab is selected.
NOTE : Some devices require that the power control bit (PC1) be set to 0 before changing the register values. Otherwise, the register value changes
are not applied. After registers are edited, the PC1 bit must be set back to 1 to enable the device again.
NOTE : When switching to the Plotter view, do not press the Streaming button again. When the Streaming button is disabled and enabled again,
the default registers values as set in the stream configuration will be written to the device!
NOTE : When a full-scale range of the device is changed (e.g., g-range of the KX132-1211 accelerometer), the SI units (m/s^2) will not be shown
correctly in the plotter view and the Digital Output sub-channel view ( 1.4.1.1 Raw data ). The counts value is not affected.
NOTE : When registers have been changed, “(MODIFIED)” text will be shown after the stream name in the Plotter View area ( Figure 63) .
NOTE : When ODR value has been changed through the register editor, the “ODR has not reached the target value” pop-up message may appear
because the new real-time ODR is significantly different from the original ODR value defined in the stream ( Figure 63 ). The ODR pop-up message
can be disabled through the View menu ( 1.3.8. View - Menu )
Figure 63. The Plotter View After Modifying the Register Values