Rohm RKX-EVK-001, User Manual

Page: 14 / 56

14/55
© 2022 ROHM Co., Ltd. No. 64UG118E Rev.002
Feb.2022
User’s Guide
1.3.5.4
COM port
When there are multiple devices connected or there is some problem with the USB COM port selection, the COM port can be selected from the
dropdown list. Before doing this the “Auto-connect” feature must be disabled.
1.3.5.5
Reset connection
If you are having connection problems, “Reset connection” can be used for to refresh the current connection. This also initializes the current data
stream again.
1.3.5.6
Reinitialize board
Reinitialize the host adapter board (and IC).
1.3.6
Stream - Menu
The Stream menu can be used to pre-configure applicable devices to operate in certain modes. It can also be used to define how data is received
or processed from other devices. The list of streams is dynamic and will change according to the chosen board configurations ( 1.3.7 Board –
Menu ). For example, if the RKX-EVK-001 / Accelerometer EVB / SPI board configuration is selected from the Board menu, the KXTJ3 sensor will
not be shown in the Stream menu because it does not support an SPI interface. However, when the RKX-EVK-001/Accelerometer EVB/I2C board
configuration is selected, the KXTJ3 sensor will be shown ( Figure 20) .
Figure 20. RKX EVK GUI SW sensor stream menu
In the case of BU79100G-LA-EVK-001, the stream menu ( Figure 21 ) can be used to pre-configure the device to operate in a specific mode.
Figure 21. ADC data streaming menu
NOTE: The ROHM EVK GUI SW will store the last used stream configuration and it will be loaded in the next application startup.