Rohm RKX-EVK-001, User Manual

Page: 15 / 56

15/55
© 2022 ROHM Co., Ltd. No. 64UG118E Rev.002
Feb.2022
User’s Guide
1.3.7
Board – Menu
The board menu is used for selecting the EVK HW what is going to be used. For ADC evaluation, the available board configuration is limited to
the” RKX-EVK-001 / BU79100G-LA-EVK-001 ADC” ( Figure 23 ). For sensor evaluation, the ROHM EVK GUI SW supports multiple host adapters
(Arduino UNO R3, CY8CKIT-059 Prototyping Kit, nRF52840-DK) – and each in turn supports one or two communication interface protocols (I2C,
SPI). The correct board configuration must be selected based on the host adapter used and the communication interface protocol supported by
the sensor that is being evaluated.
NOTE: The Board menu lists either all supported board configurations for all supported Host Adapters ( Figure 23) or only the relevant ones ( Figure
22 ) that are supported by the Host Adapter currently plugged in, e.g., CY8CKIT-059 / RKX-A3-EVK-001 / that comes with the ROHM EVK package
by default. The selection is done via the View menu ( 1.3.8 View – Menu ).
Figure 22. The Board Menu when “Show all board configurations” is not selected
Figure 23. The Board menu when “Show all board configurations” is selected
The default board configuration is “RKX-A3-EVK-001 /Accelerometer Module / I2C”.
For ADC, the available board configuration is limited to the” BU79100G-LA-EVK-001”.