Rohde KE 100 L, Instruction Manual

Page: 23 / 80

Status: 01 / 2016 Page
23
of 80
en
gli
sh
5.5. Place the kiln on its legs
If your Frontloader has not been set up by the ROHDE delivery and set-up service, it is
now time to place the kiln on its legs. Lift the Frontloader using a forklift.
Insert the forks under the kiln door and move them carefully towards the back of the
kiln.
Please make sure that the power cable and AMP socket are not damaged!
Lift the kiln to a position where you can easily mount the legs. Please note that the legs
and mounting positions are marked in red and green. They must be mounted accor-
dingly. Mount the legs on to the kiln with the fi xing screws and lower the kiln into the
position required.
5.6. Exhaust air socket
KE-L series 55 - 70
Place the exhaust tube into the exhaust air opening (fi gure
4) on the kiln ceiling.
Mount the exhaust air socket (optional accessory) into
the holes at the position indicated (fi gure 5a).
Plug the exhaust air tube (optional accessory) into the
exhaust air socket and use the fi xing screw to fi x it to the
socket.
Open and close the exhaust air opening using the chim-
ney brick (fi gure 5b).
KE-L series 100 - 250, KE-N and KE-S
Screw the exhaust air socket (fi gure 6) into the hole on
the ceiling of the kiln. The opening has been located in a
position that will allow fumes and gases to be released
through an exhaust air socket (optional accessory). Plug
the exhaust air tube into the exhaust air socket (fi gure 7)
and use the fi xing screw to fi x it to the socket.
5.7. Exhaust air fl ap
Rohde Frontloaders KE-N and KE-S series are equipped
with an exhaust air handle, operated from front (optional
accessory for KE 100 - 250 L).
When the handle is pushed in completely (fi gure 8), the
exhaust air opening on the ceiling of the kiln is closed
(fi gure 9).
To open the exhaust air, pull the handle out completely.
fi gure 4
fi gure 3
fi gure 5a fi gure 5b
fi gure 6 fi gure 7
fi gure 8 fi gure 9