Rohde & Schwarz SMM-K507, User Manual, Page: 13 / 51

Uploading waveform files
R&S
®
SMM-K507
13 User Manual 1179.5718.02 ─ 02
To connect to LAN
Optionally, connect the host PC and R&S SMM100A to LAN for remote control opera-
tion via the SCPI interface. Use this connection to configure RF signal settings of the
R&S
SMM100A like frequency and power level.
► Connect the LAN socket via an RJ-45 cable to the LAN.
For a detailed description, see chapter "Connecting to LAN" in the R&S SMM100A
user manual.
Table 3-2 and Figure 3-1 provide an overview on connections and the test setup.
Table 3-2: Host PC and R&S SMM100A connections
Signal Host PC R&S SMM100A
Data Electrical (10G): RJ45
Optical (10G): SFP+
Optical (40G): QSFP+
HS Dig I/Q
Control (SCPI) LAN LAN
Generator
RF
SFP+
RJ45
QSFP+
RF LAN
HS DigIQ
LAN
Figure 3-1: Test setup with host PC and R&S SMM100A
For a detailed description of the test setup, see "Test setup" on page 10.
3.2 Configuring the host PC
This chapter provides step-by-step instructions to configure the host PC for waveform
transfer. Before configuration, connect the host PC to the R&S
SMM100A as described
in Chapter 3.1, "Connecting the R&S SMM100A" , on page 12. The host PC operates
with Windows operating system. The step-by-step instructions cover the following top-
ics:
●
"To configure network settings" on page 13
●
"To prepare waveform data" on page 14
●
"To transfer waveform data" on page 14
To configure network settings
For correct waveform data transfer from the host PC to the R&S SMM100A, make sure
to configure the host PC as follows:
1. Install the latest Windows driver version of the controller of the Ethernet card.
Configuring the host PC