Operating the instrument
R&S
®
RTP
67
Getting Started 1337.9946.02 ─ 07
● Automatic measurements: select "Measurement" tab > "Result position".
● Cursor measurements: select "Cursor" tab > "Result position".
● Protocols: select "Protocol" tab > "Result position".
To arrange the results on the display
1. If the results are listed in a docked table, touch and hold a result line and drag
it.
The results are now shown in a result box.
Note:
Once you undock the measurement results, you cannot move the result
box back to the docked position.
2. Touch and hold the title of the result box and drag the box on the screen. The
SmartGrid indicates where the result box will be placed.
● If you drop the box on one of the buttons, the results are shown in a sepa-
rate tab besides, above, or below the diagram.
● If you drop the box on the signal bar, a result icon is created.
● If you drop the box somewhere else, a floating result box is placed.
1 = Floating result box
2 = New tab
3 = Table in a tab above or below
4 = Table in a tab on the left or right
Displaying results
