Subject to change without notice
8
Probe RT-ZS10L
Safety Information RT-ZS10L
To avoid personal injury and to prevent fire or
damage to this product or products connected
to it, review and comply with the following safety
precautions. Be aware that if you use this probe
assembly in a manner not specified the protection
this product provides may be impaired.
– Only qualified personnel should use this probe
assembly.
– Use only grounded instruments.
– Do not connect the probe ground lead to a
potential other than earth ground. Always make
sure the probe and the measurement instrument
are grounded properly.
– Connect and disconnect properly.
– Connect the probe output to the measurement
instrument and connect the ground lead to earth
ground before connecting the probe to the cir
-
cuit under test. Disconnect the probe input and
the probe ground lead from the circuit under
test before disconnecting the probe from the
measurement instrument.
– Do not apply any electrical potential to the probe
input which exceeds the maximum ratings of the
probe.
– Make sure to comply with the voltage versus
frequency derating curve.
– Keep away from live circuits.
– Avoid open circuitry. Do not touch connections
or components when power is present.
– Do not operate with suspected failures.
– Refer to qualified service personnel.
– Indoor use only.
– Do not operate in wet/damp environment. Keep
product surfaces dry and clean.
– Do not operate the product in an explosive
atmosphere.
Safety symbols
The following symbols may appear on the product
or in this manual:
Caution, risk of danger
Refer to manual
Caution, risk of electric schock
Earth (ground) terminal
