Rohde & Schwarz NRP-Z Series, Getting Started

Page: 35 / 40

Operating Concepts
R&S
®
NRP-Zxx
35 Getting Started 1176.8822.02 ─ 04
Setup
Figure 6-3: Setup with an R&S SMF
1 = R&S SMF
2 = Device under test (DUT)
3 = R&S
NRP
‑
Z icon
4 = [SENSOR] connector
5 = R&S NRP
‑
Z Power Sensors
6 = RF output of the DUT
7 = [RF OUT] connector of the R&S
SMF
8 = RF input of the DUT
Incorrectly connecting/disconnecting the R&S NRP
‑
Z power sensors may
damage the power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensors as described in
Chapter 4.4, "Connecting the R&S NRP
‑
Z Power Sensors" , on page 14 and
Chapter 4.5, "Disconnecting the R&S NRP
‑
Z Power Sensors" , on page 16.
Starting a measurement
1. Connect the cables as shown in Figure 6-3 :
a) Connect the DUT to the [RF OUT] connector of the R&S SMF.
b) Connect the DUT to the [RF] connector of the power sensor.
c) Connect the power sensor to the [SENSOR] connector of the R&S
SMF.
2. On the R&S SMF, open the "NRP-Z Power Viewer" dialog.
Compatible Instrument