Rohde & Schwarz NRP-Z Series, Getting Started

Page: 23 / 40

Connecting to a PC
R&S
®
NRP-Zxx
23 Getting Started 1176.8822.02 ─ 04
10 = Triggered device (optional)
11-14 = R&S NRP
‑
Z power sensor
15 = Signal source
Incorrectly connecting/disconnecting the R&S NRP
‑
Z power sensors may
damage the power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensors as described in
Chapter 4.4, "Connecting the R&S NRP
‑
Z Power Sensors" , on page 14 and
Chapter 4.5, "Disconnecting the R&S NRP
‑
Z Power Sensors" , on page 16.
1. Connect the cables as shown in Figure 5-3 :
a) Connect the power sensors to the R&S NRP
‑
Z5 sensor hub. You can con-
nect up to four sensors.
b) Connect the R&S NRP
‑
Z5 to the computer.
c) Connect the power sensors to the signal source.
d) Connect the delivered external power supply unit to the R&S
NRP
‑
Z5 and
to an AC supply connector.
e) Connect the R&S NRP
‑
Z5 with a BNC cable to the trigger source
(optional).
f) Connect the R&S NRP
‑
Z5 with a BNC cable to the trigger device
(optional).
2. On the PC, start a software application to view the measurement results. See
Chapter 6, "Operating Concepts" , on page 24.
Using an R&S NRP
‑
Z5 Sensor Hub