Rohde & Schwarz ESRP Series, User Manual

Page: 358 / 1094

Spectrum Measurements
R&S
®
ESRP
355 User Manual 1175.7445.02 ─ 08
Video Output ............................................................................................................... 355
Trigger Out .................................................................................................................. 355
Probe Config ............................................................................................................... 355
Input (AC/DC)
Toggles the RF input of the R&S ESRP between AC and DC coupling.
Remote command:
INPut:COUPling
on page 641
Preselector (On Off)
Turns the preselector on and off.
The preselector is available with option R&S ESRP-B2.
Remote command:
INPut:PRESelection:STATe
on page 899
Noise Source
Switches the supply voltage for an external noise source on or off.
For details on connectors refer to "NOISE SOURCE CONTROL" on page 31.
Remote command:
DIAGnostic<n>:SERVice:NSOurce
on page 899
Video Output
Selects the type of output for the optional IF / Video output.
When you turn on the output, you can select to output either the intermediate fre-
quency or the video signal.
Note: Video output does not return valid values in IQ or FFT mode.
Remote command:
OUTP:IF VID
, see
OUTPut:IF[:SOURce]
on page 900
Trigger Out
Sets the Trigger Out port to low or high. Thus, you can trigger an additional device via
the external trigger port, for example.
Remote command:
OUTPut:TRIGger
on page 901
Probe Config
Opens an edit dialog box to activate and configure a connected probe which is to pro-
vide an input signal. It is only available if a probe is connected to the instrument's [RF
Input] and USB connectors.
For details see Chapter 6.2.9.2, "Using Active Probes for Input" , on page 356.
Remote command:
PROBe[:STATe]
on page 790
PROBe:SETup:MODE
on page 789
Configuration