Rohde & Schwarz ESRP Series, User Manual

Page: 792 / 1094

Remote Control
R&S
®
ESRP
789 User Manual 1175.7445.02 ─ 08
PROBe:ID:PARTnumber?
This command returns the material part number of the connected probe.
Example: PROB:ID:PART?
Usage: Query only
Manual operation: See "Part number" on page 358
PROBe:ID:SRNumber?
This command returns the serial number of the connected probe.
Example: PROB:ID:SRN?
Usage: Query only
Manual operation: See "Serial Number" on page 358
PROBe:SETup:MODE <Mode>
This command defines which action is taken when the probe's micro button is pressed.
Parameters:
<Mode> RSINgle
A single sweep is performed.
NOACtion
No action is taken.
*RST:
OFF
Example:
PROB:SET:STAT ON
Manual operation: See "Probe Config" on page 355
See "Micro Button Action" on page 358
PROBe:SETup:NAME?
This command returns the name of the connected probe.
Example: PROB:SET:NAME?
Usage: Query only
Manual operation: See "Name" on page 358
PROBe:SETup:STATe?
This command queries whether a probe is connected to the instrument's [RF Input] and
USB connectors and was recognized by the R&S
ESRP.
Example: PROB:SET:STAT ON
Usage: Query only
Remote Commands in Spectrum Analyzer Mode