Rohde & Schwarz ESRP Series, User Manual

Page: 904 / 1094

Remote Control
R&S
®
ESRP
901 User Manual 1175.7445.02 ─ 08
*RST: IF
Example: OUTP:IF VID
Selects the video signal for the IF output connector.
Manual operation: See "Video Output" on page 355
OUTPut:TRIGger <PortLevel>
This command selects level of the Trigger Out port. Thus, you can trigger an additional
device via the external trigger port, for example.
Parameters:
<PortLevel> LOW | HIGH
*RST:
LOW
Example: OUTP:TRIG HIGH
Manual operation: See "Trigger Out" on page 355
OUTPut:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S ESRP.
Parameters:
<State> ON | 1
User port is switched to OUTPut
OFF | 0
User port is switched to INPut
*RST:
0
Manual operation: See "User Port" on page 163
OUTPut:UPORt[:VALue] <Value>
This command sets the control lines of the user ports.
The assignment of the pin numbers to the bits is as follows:
Bit 7 6 5 4 3 2 1 0
Pin N/A N/A 5 3 4 7 6 2
Bits 7 and 6 are not assigned to pins and must always be 0.
The user port is written to with the given binary pattern. If the user port is programmed
to input instead of output (see
INPut<ip>:UPORt:STATe
on page 900), the output
value is temporarily stored.
System Configuration