Instrument tour
R&S
®
RTO6
30
Getting Started 1801.6670.02 ─ 04
8 = Option slot for R&S
RTO6-B1 (MSO, shown in figure) or R&S
RTO6-B1E (for R&S
RT-
ZVC), or R&S
RTO6-B10 (GPIB)
9 = Kensington lock slot to secure the instrument against theft
10 = Ref In, Ref Out: reference input, and output of the OCXO reference signal
11 = External trigger input
12 = External trigger output
13 = Slot for optional exchangeable solid state disk (option R&S
RTO6-B19)
AC power supply connector and main power switch
Connection to the AC power line. The R&S
RTO6 can be used with different AC
power voltages and adapts itself automatically to it. The nominal voltage and fre-
quency ranges are displayed on the rear panel and quoted in the data sheet.
If grounding is
not
ensured by the mains system, ground the oscilloscope using
the protective earth conductor on the front panel and an appropriate cable.
The AC main power switch also interrupts the power supply of the OCXO.
When you power up the instrument, be sure to comply with the warm-up phase
specified in the data sheet before you start measurements.
USB Device
USB 3.0 interface of type B (device USB), to be used for remote control of the
instrument.
USB
Two USB type A connectors that comply with standard USB 3.1 gen 1. They are
used to connect devices like keyboard, mouse and flash drive to store and reload
instrument settings and measurement data.
Note:
Electromagnetic interference (EMI) can affect the measurement results. To
avoid any impact, do not use USB connecting cables exceeding 1
m.
LAN
8-pin RJ-45 connector used to connect the instrument to a Local Area Network
(LAN). It supports up to 1000 Mbit/s (10/100/1000BASE-T Ethernet).
HDMI
HDMI Version 2.0 connector for an external monitor or projector. The monitor
shows the complete content of the instrument's screen.
DisplayPort
DisplayPort connector for an external monitor or projector. It supports DisplayPort
++ version 1.3.
Rear panel
