Rohde & Schwarz 1440.8002.02, Getting Started

Page: 81 / 95

Instrument control
R&S
®
SMM100A
81 Getting Started 1179.1335.02 ─ 04
1 2 3 4 5
Figure 7-3: Taskbar fully assigned
1 = System configuration
2 = Remote control connections
3 = Graphics
4 = Dialogs
5 = Diagram / more
1 System Config Provides access to general system configurations
like setup, display, or remote.
2 Remote Shows the established remote connections when
the instrument is remotely controlled.
Tip: An indicator in the status bar shows the current
remote control status.
3 Graphics Shows that a signal is represented graphically.
4 Dialogs Shows a dialog as a thumbnail, the dialog name,
and the name of signal channel.
5 Diagram / more The diagram icon as shown in Figure 7-2 minimizes
all dialogs indicated on the screen. The block dia-
gram is in the foreground.
The "More" softkey indicates that more dialogs are
open than can be displayed in the taskbar. Use this
softkey to open a selection list with the remaining
active dialogs, and the "Diagram" function.
7.3.4 Additional display characteristics
The following section provides a short insight on the indication of the screen in
general, and significant elements that you see under specific operating modes, in
dialogs or settings.
●
Appearance of active elements
– Active elements like On/Off switches, state buttons have a blue back-
ground.
– Selected elements are framed or highlighted orange .
– Inactive elements are gray .
●
On-Screen keypads
Understanding the display information