Roger PRT12EM, Installation And Programming Manual

Page: 20 / 59

PRT-EM Series Readers fv 1.29 and 2.29 Rev. J.doc 2012-01-05
Page 20 from 59
205 Disarming by input Reader has been disarmed by input line [24]:
Arming/Disarming Key Switch
006 Summer time Clock has been pushed backward by 1 hour
007 Winter time Clock has been pushed forward by 1 hour
109 Door bell Door bell indication triggered
300 Forced entry Door opened in unauthorized way
304 Door ajar Door open to long
301 Prealarm Five consecutive attempts to enter wrong PIN or card
within 5 minutes – Prealarm signaling started
112 Unknown card The unknown card has been entered (card code)
113 Unknown PIN The unknown PIN has been entered (PIN code)
003 User Programming Reader switched to User Programming mode
004 Installer Programming Reader switched to Installer Programming mode
005 Online mode Reader switched to online communication mode with PC
000 Reader restarted Reader passed through initialization procedure (the
same as during power on)
001 Clock cleared The internal clock of the reader has been cleared
002 Clock changed The internal clock of the reader has been programmed
302 Tamper Alarm Reader entered Tamper Alarm state
303 Intruder Alarm Reader entered Intruder Alarm state
305 Duress Alarm Reader entered Duress Alarm state
999 Unknown event Event code doesn’t fit any known event – error in data
5.13. R
EAL
T
IME
C
LOCK
The PRT-EM is equipped with Real Time Clock (RTC) predefined for 100 year. This clock is used to
append a time stamp to every event recorded by the reader. The RTC clock has not battery back-
up so it resets to 2000-01-01 00:00 whenever power is off. When required, the RTC can be
configured to switch automatically to winter or summer time.
Note: Normally, when reader’s Real Time Clock is unset (or lost due to lack of power supply)
reader continues its operation however this can be changed. When option
Real Time Clock
Control is active reader will stop its operation till moment when clock will be programmed again
(see Installer Programming, function [78] .
5.14. T
IMERS
Reader uses several timers, each timer is assigned to specific function and can be programmed in
seconds or minutes.
ID Timer Defaults Function
0 Door Unlock Time
(00-99 sec./min.) 4 sec. Defines time for which door lock will be released.
This timer controls following outputs:
[41]: Door
Lock , [42]: Door Lock Exit , [43]: Door Lock
Entry.