Roger PRT12 v1.3, Installation And Programming Manual

Page: 10 / 40

PRT12 v1.3 fv75.6 EN Rev.D.doc 10/22/2007
_________________________________________________________________________________________
Page 10 of 40
Note: When you program a user using full programming procedure, you will be able
later to selectively delete him by entering his ID number. If you program card/PIN
using a simple programming procedure then to remove a given card/PIN from a
reader you must present card to a reader or enter PIN code to be deleted,
otherwise the only one method to remove it from memory will be
Memory Reset .
6.3. User identification
In PRT12 user can be identified by card, PIN or both (card and PIN). The method
which reader uses for user’s identification depends on the actual
Identification
Mode . The PRT12 enables following Identification Modes :
 Card or PIN , the reader requires card or PIN, only one of them is necessary for a
successful identification
 Card and PIN , the reader requires card and PIN, both are necessary for a
successful identification
Note: The Identification Mode can be set individually for primary and secondary
reader.
6.4. Armed and Disarmed Modes
When in the Stand-alone mode reader may be Armed or Disarmed . The actual
operation mode of the reader is indicated on the dual color LED STATUS , which
lights in red for
Armed and green for Disarmed . The actual mode in which reader is
can be indicated on an output line configured to option Disarmed Mode . Such a
configuration allows the output line to be used as a driver to Arm/Disarm a
connected alarm system or to switch on/off some other auxiliary system or device
(e.g. heating, lights etc.). In general the reader’s
Armed/Disarmed states have no
effect on door unlocking, unless the Access disabled when reader armed option
will be enabled. With this option activated, access to the supervised room my be
granted only when reader operates in
Disarmed mode.
Using the option mentioned above the TOGGLE and TOGGLE LTD users are capable
to enable or disable access to the supervised room, also it allows automatic access
locking upon a reader entering the
Armed mode.
Note: Although the Armed and Disarmed modes of the reader were originally
designed for integration with the alarm system, they can be successfully used for
any other purpose which requires an on/off control method (light control, heating
control etc).
Note: Upon powering on, the PRT12 automatically returns to the arming mode
(either;
Armed or Disarmed ) it was in before powered off. Also, the reader returns
to its original Armed/Disarmed state after leaving the programming mode. After
Memory Reset controller always enters the Armed mode.
6.5. Arming and disarming of a reader
The action changing the reader from Armed to Disarmed and back (i.e. reverse