MCT12E Operating Manual
05.10.2020
9/14
Fig. 7 Typical connection diagram for the
–IO version terminal and MC16 access controller
4.
C
ONFIGURATION
Low level configuration (RogerVDM)
The purpose of low level configuration is to prepare device for operation in RACS 5 system.
Programming procedure with RogerVDM software:
1. Connect the reader to RUD-1 interface (fig. 8) and connect the RUD-
1 to computer’s USB port.
2. Start RogerVDM program, select
MCT
device, firmware version,
RS485
communication channel and
serial port with RUD-1 interface.
3. Click
Connect,
the program will establish connection and will automatically display
Configuration
tab.
4. Enter unoccupied RS485 address in range of 100-115 and other settings according to requirements of
specific installation.
5. Click
Send to Device
to update the configuration of reader.
6. Optionally make a backup by clicking
Send to File…
and saving settings to file on disk.
7. In the top menu select
Device->Disconnect.
8. Disconnect reader from RUD-1 interface.
Note: Do not read any cards nor press keypad when reader is configured with RogerVDM.
