MCT12E Operating Manual
05.10.2020
8/14
Note: New device is assembled with standard back panel with 23mm thickness but additional back panel
with 35mm thickness is included. Such panel can be used if more space for connection cable is needed and
it may also improve card reading distance if the terminal is mounted on metal surface.
Installation guidelines
The terminal should be mounted on a vertical structure (wall) away from sources of heat and
moisture.
Front panel should be attached in such way as the tamper detector (fig. 4) would firmly press the
back panel.
All electrical connections should be done with disconnected power supply.
If the terminal and controller are not supplied from the same PSU then GND terminals of both
devices must be connected with any wire.
Device can be cleaned by means of wet cloth and mild detergent without abrasive components. In
particular do not clean with alcohols, solvents, petrol, disinfectants, acids, rust removers, etc.
Damages resulting from improper maintenance and usage are not covered by manufacturer
warranty.
3.
O
PERATION SCENARIOS
The terminal when connected to MC16 access controller can be at the same time used for access control
and Time&Attendance. The example of connection diagram for such scenario is shown in fig. 6 where inputs
and outputs from MC16 board are used and in fig. 7 where inputs and outputs from
–IO version terminal are
used. The terminal can also operate with MC16 controller using MCX2D/MCX4D expanders as in case of
M16-PAC-KIT series. Various scenarios of operation with MC16 controllers are presented in AN002
application note.
Fig. 6 Typical connection diagram for the terminal and MC16 access controller
