EN
72
CLOSE
TEST
SEE CHAPTER 16 and 17
ACQUISITION
PROCEDURE
CHAP. 11.2
ACQUISITION
PROCEDURE
CHAP. 11.2
fC
fC
15
15
YES
No
ta
ta
da
da
No
Press and hold on
TEST
TEST
TEST
PROG
AP P-
Until ...
1 click
1 click
1 click
1 click
11.2
Acquisition procedure:
PROG
AP P-
PH A5
AU to
x4 s
Wait ...
OPENING
OPEN
CLOSING
(if FT input are
connected or enabled)
CLOSE
Yes
AU
AU to
to
PH
PH A5
A5
FO
FO TO
TO
• Press and hold
PROG
for 4 seconds.
$3 3
is shown on the display.
• Open the release handle. The message
3+ $6
appears on the display after a few seconds. The controller unit
launches a calibration procedure. The operating parameters of the motor are determined during calibration.
• If the motor calibration procedure is successful, the message
3+ $
ƽEWLIWSRXLIHMWTPE]
• Close the release handle. The acquisition procedure now starts.
•
)2W2
is shown on the display (only if parameters
,
,
,
are not disabled). Keep away from the
photocell beam within 5 s, to prevent interrupting the procedure.
•
$XWR
is shown on the display and the gate starts opening at low speed.
•
8LIKEXIWXSTWFVMIƽ][LIRMXVIEGLIWXLIKEXISTIRPMQMXW[MXGL
$XWR
ƽEWLIWSRXLIHMWTPE]
• The gate closes until it reaches the gate closed limit switch.
If the acquisition procedure is completed successfully, the display enters the command and safety device state
display mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
•
QR3+
: calibration procedure failed.
•
$33(
: acquisition error. Press the
TEST
button to clear the error, and check the safety device in alarm state.
•
$33/
: travel length error. Press the
TEST
button to clear the error, and check that gate is completely closed.
For more information, see chapter 17 “Alarms and faults”.
Summary of Contents for B70/1DC
