Rodgers Allegiant 657, Owner'S Manual

Page: 67 / 76

57
FACTORY DEFAULT COMBINATION SETTINGS
The Rodgers 657/677 is shipped from the factory with default settings in combination memories
M1 , M2 . Registrations of these memories can be changed, but if the original factory default
settings are desired, they can be restored by the following procedure:
1) Press and hold a memory select piston ( M1 or M2 ) for approximately five seconds. The
display will show LOCKED or UNLOCKED.
2) While holding the memory piston, press and hold the SET piston for an additional five
seconds. The display will read MEMORY BANK FACTORY DEFAULT.
3) Release both pistons.
The memory in the chosen bank has been restored to its factory settings.
Note: To fully restore the factory default combination settings, each memory must be
individually restored by following the procedure above. Also, the 677 does not have factory
default settings in combination memories
M3 and M4 ; therefore, if these memories are reset to
their factory default settings, they will be blank.
Restoring All Other Factory Default Combination Settings
To restore the Factory Default Combination Settings:
1. Press and hold SET + PIPES OFF while inside General Menu for
approximately five seconds. The display shows LOCKED or UNLOCKED .
2. While holding M1 , press and hold SET for an additional five seconds until the
display shows MEMORY 1 FACTORY DEFAULT .
3. Release both pistons.
The memory has been returned to factory defaults, except Combination Memories.
Recalling the Last-Saved Version of the General Menu and ORCH/MIDI Menu
Settings
1. Press and hold the Cancel ( 0 ) piston, then momentarily press the SET piston.
Note: This action resets the following parameters:
a) Sets the TEMPERAMENT to EQUAL.
b) Sets the Voice Palette to the last-saved voice for each stop.
c) Sets the MIDI coupler parameters to their power-up default.