12
GB
Märklin*6021
1
Trigger a
reset
(press “Stop“ and “Go“ simulta-
neously for a few seconds).
2 Switch off power to rails
(“Stop“)
3
Enter two-digit
locomotive address
or “80“
4
Press
travel direction selector
, keep depressed
and
also
press
“Go“
:
The decoder is in the programming mode and is
waiting for the register number to be entered:
short flash
at long intervals.
5
Enter two-digit
register number
(CV).
6
Press
travel direction selector
:
The decoder is waiting for a value to be entered:
combination of long/short tones in quick succes-
sion.
short double flashing
at long intervals.
7
Enter two-digit
value
.
8
Press
travel direction selector
:
The decoder first confirms the value has been
entered with a long
glow
This is followed by shor
flashing at long intervals as it waits for a new
register number to be re-entered.
9
Either reprogram the desired
next register
with
steps No. 5 to 8
or
enter
“80“ for the end of
programming.
10
Press
travel direction selector
Please note that the Märklin* 6021 only allows you
to enter the values 01 to 79. The value 0 does not
appear. Instead of „00“ the value „80“ must be
entered instead.
Programming with the Märklin*
Mobile Station
Attention!
Only Märklin* locomotives are included in the Mär-
klin* Mobile Station Databank.
For docking Roco Locomotives in the Märklin*-
Mobile Station, use one of the two universal numbers
36330/37962. They are to be set this way:
Dock the locomotive in the databank:
1.
The knob must be set to 0.
2.
Press the ESC button.
3
. Turn the knob to the menu option (“New
Locomotive”).
4.
Press the knob.
5
. Turn the knob to the menu option (“Databank”).
6
. Press the knob.
7.
Choose one of the two universal numbers with
the knob (we recommend starting with 36330)
8
. Press the knob
8036025922 (neues Format).indd 12
30.08.2017 11:45:45
