15
BladeRunneR
®
enG
TROuBleSHOOTInG
Symptom
Possible Causes
Possible Solution
Tool will not start when power
on.
• Power cord is not plugged.
• Check to make sure power cord is connected
well into a working outlet.
finishing surface is not good.
• Blade is worn out.
• Blade is set incorrectly
• Check to make sure the blade is sharp and
not broken.
•Check to make sure the blade is adequately
installed.
Work efficiency is low.
• Blade is worn out.
• Incorrect speed setting.
• Change to a new blade.
• Adjust the variable speed control according
to the material, material thickness and blade
specification to be used as described in Chart 1.
Blade is not clamped tightly by
the blade holder.
• Blade is not inserted into
place.
• Use blade grip to push the blade as far into
the blade holder as possible.
Blade release button cannot be
pressed down.
• Dust accumulates.
• Clean the dust around the blade release
button.
support arm vibrates too
much.
• Screws fixing the Support
arm on the work table are
loose.
• Tighten the screws as shown in Fig A3.
Blade deviates from the center
position when working.
• The support arm was
not adjusted to the correct
position when it was mounted
to the work table.
• Loosen screws fixing the support arm. Lower
the guard arm. Make sure the blade rests in the
center between the guide rollers. Then hold the
support arm in place and tighten the screws.
Rip fence sliding face cannot
slide into fence slot smoothly.
• Rip fence locking knob too
tight.
• Loosen the rip fence locking knob.