BladeRunneR
®
enG
14
pressure foot is firmly against the workpiece.
e) Perform the cut according to General Cutting Rules.
f) at the completion of the cut, again unplug the saw, raise the
guard arm to remove the work.
g) always remember to return the guard arm to the lowered
position when finished.
7. duST COlleCTIOn (See Fig. n & P)
dust and chips from cutting will be collected in the dust (16) drawer
at the bottom of the machine.
nOTe: To ensure optimal dust collection, empty the dust
drawer when it becomes filled to approximately 2/3 of its
capacity.
for better cut line visibility and cleaner working environment,
connect a vacuum cleaner or dust extractor to the vaccum port (10)
on the blade guard.
a vacuum MuST be used for hazardous dusts such as tile
cutting.
8. CaRRY Handle (See Fig. O)
BladeRunner
®
has a built-in carrying handle (2) on the side for easy,
convenient transporting from one job site to another. Before carrying
the saw, shut off the power and pull out the plug.
nOTe:
a) When carrying the saw, accessories shall be stored properly or
locked up to avoid being lost.
b) Before carrying the saw, please empty the dust drawer.
MaInTenanCe
WaRnInG:
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
To insure proper operation and extend tool life, prevent dust from
accumulating under the table insert (12).
a) Be sure to use a vacuum or dust extractor for dusty cutting
operations such as ceramic tile. (see fig. P)
b) if dust accumulates remove the table insert by lifting the
latch(e). (see fig. Q)
c) Vacuum out the dust in and around the blade holder. (see fig. R)
d) Reattach the table insert securely.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
if you see some sparks flashing in the ventilation slots, this is normal
and will not damage your power tool.
if the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
e
Q
R
P
10
N
16
O