BladeRunneR
®
enG
10
and raise the guard arm (see fig. B1). Wear gloves to protect your
fingers from the sharp blade. Remove the desired jigsaw blade from
the blade storage drawer. attach the blade grip (found in the small
plastic bag) over the tip of the blade (see fig. B3). Make sure the
grip slides down the blade as far as it will go. hold the blade by the
grip. Open the blade holder by depressing the blade release button,
and pull the release lever firmly and completely to the right. hold
the blade release open and insert the blade into the blade holder
using the blade grip. Push the blade as far into the hole as possible,
making sure the teeth are oriented perfectly toward the front of the
saw. Continue to hold the blade in place and allow the blade release
lever to slide slowly back to the left. The blade should now be locked
in the proper position. if not, pull the blade release fully to the right
and try again. The blade will seat properly if the blade release is
pulled fully open, the blade is pushed firmly to the bottom of the hole
and held there, and the blade lever is released smoothly. Remove the
blade grip from the blade by pulling it upward.
nOTe: The BladeRunner
®
is designed to use jigsaw blades 4”
overall length or less. do not use jigsaw blades longer than
4”. use blades with a t-shank only.
3. STORInG THe BladeRunneR aCCeSSORIeS
a) Miter gauge / rip fence (See Fig. C1,C2)
adjust the miter gauge/rip fence to the position as shown in
fig C2 and tighten the lock knob. Then press the miter gauge/
rip fence into the miter gauge storage on left side of the
BladeRunner
®
.
B3
B4
B5
C1
C2