Rockwell Automation Publication CC-QS027D-EN-P - August 2015
31
Chapter
2
Validate Your System
This chapter provides instructions on how to configure, connect, and validate communication between the devices in your
900-TC temperature control device building-block system.
Before You Begin
• Complete the steps in
• Verify that the devices are connected as shown in the assembled wiring diagrams.
• Verify that your Micro800 controller, the 900-TC Temperature Controller, and the PanelView 800 terminal have
power applied to them.
What You Need
• Micro820, Micro830, or Micro850 controller with Isolated Serial Port plug-in module (catalog number
2080-SERIALISOL)
• 900-TC8 or 900-TC16 temperature controller
• 4 in. (or larger) PanelView 800 terminal
• 1761-CBL-PM02, 9-pin to 8-pin MINI-DIN RS-232 communication cable, if a CIP serial connection for the
PanelView 800 terminal is used
• Two 1585J-M8
xxxx
-2 RJ45 Ethernet patch cords, if a CIP on Ethernet connection for the PanelView 800 terminal
is used
• 1783- US
xxx
Stratix 2000™ unmanaged Ethernet switch
• Two-wire, twisted-pair shielded RS-485 communication cable (Belden 3105A recommended)
• 900-TC
xxx
COM card (one per 900-TC temperature controller)
• AK-U0-RJ45-TB2P, RJ45 two position terminal block with a 120
terminating resistor
• USB programming cable (A to B) or Ethernet cable for personal computer to Micro800 controller communication
• Personal computer with available USB port and Ethernet connection with Connected Components Workbench
software, version 6 or later, installed
