18
Rockwell Automation Publication CC-QS027D-EN-P - August 2015
Chapter 1
900-TC Temperature Controller Setup
7. Press the
key for at least one second to move from the Advanced Setting function group display (G) to the Initial
Setting function display (H).
8. Press the
key for at least one second to move from the Initial Setting function group display (H) to the Operation
function group display (A).
Set Parameters with 900Builder Lite Software and 900-CPOEM1 Cable (optional)
Use the 900Builder Lite software, version 3.0, to configure the temperature controller parameters.
Install the 900Builder Lite Software and the USB Driver
Follow these steps to install the 900Builder Lite software on your personal computer.
1. Double-click the Set-up icon or double-click the ‘run setup.exe’ file.
Full instructions for set-up options are available during the set-up process.
2. As part of the installation, choose a location for where to place the 900Builder Lite software icon.
To install the USB driver on your personal computer, follow the directions in the Bulletin 900 Direct USB to Temperature/
Process Controller Configuration Cable Installation Instructions, publication
.
A
B
C
D
E
F
G
H
IMPORTANT
The 900Builder Lite software, version 3.0, supports the 900-TC8 Series B, 900-TC16 Series B, and 900-TC32 Series B temperature
controllers.
TIP
Administrator privilege is required to perform 900Builder Lite software installation.
TIP
After the installation, you can also choose Start > Programs > Rockwell Automation > 900Builder Lite to view the
900Builder Lite software icon.