Publication 1794-6.5.12 - September 2011
Install Your FLEX I/O Input Module
11
2.
Check to make sure that the 16 pins in the male connector on the
adjacent device are straight and in line so that the mating female
connector on this terminal base unit will mate correctly.
Make certain that the female FlexBus connector is fully retracted into
the base unit.
3.
Position the terminal base at a slight angle and hooked over the top of
the 35 x 7.5 mm DIN rail A (Allen-Bradley part number 199-DR1;
46277-3).
4.
Slide the terminal base over tight against the adapter, or proceeding
terminal base. Make sure the hook on the terminal base slides under the
edge of the adapter, or proceeding terminal base, and the FlexBus
connector is fully retracted.
1
2
3
4
6
7
7
8
9
0
2
+
2
+
45319
2
+
2
+
45320
Summary of Contents for Allen-Bradley 1794-IRT8K
