RocHobby ROC11242RTRCE, Instruction Manual

Page: 13 / 44

Lighting function
13
Getting started
Transmitter Battery Installation
We start with engine. The Boxer air-cooled engine serves as the core of the car, an engine used in
several later generations of classic cars and lasted 65 years in the Beetle, a saga that came to an end
when the last Beetle, number 21,529,464, rolled off the production line in Puebla, Mexico, on July 30,
2003. Initially the Type82 used a 985cc engine, later upgraded to 1131cc, then gradually increased
displacement, and in the Porsche 356 used a 1488cc engine, doubling the horsepower from the very
beginning. The cylinders of the horizontally opposed engine are distributed on both sides, a 130 motor in
the right cylinder position, and another 130 motor reserved for the left side, which can output twice as
much power when applied to the VW T1 or Porsche356 platform. The engine crankshaft flywheel is
connected by a belt to drive the generator and the cooling fan as well. The semi-circular fan fairing is a
major feature, in which the airflow is distributed to the cylinders on both sides. All is faithfully restored on
the model, meaning you can observe the blades rotating through the fan intake when the motor is
running. The Kübelwagen has 4 forward gears and the maximum speed of each gear respectively goes
as 1st gear 18.4km/h; 2nd gear 32.4km/h; 3rd gear 54.2km/h; 4th gear 83.6km/h. The corresponding red
line of gearshift tips is available on the dashboard. On the model, we designed a 2-speed shift to simulate
the speed of the 1st and 3rd gears of the real car. The power crosses over from the top of the rear axle
differential and then returns to the rear axle. The model shares the same structure as the real engine,
with the benefit of compactness, making it easy to switch between 4WD and RWD modes. This shift
function is perfectly reproduced on the model to provide more driving pleasure when driving off-road.
EN
Times for Pressing
Button Light
Position
Headlight
Taillights
CH4
White
headlights
keep on
White
headlights
keep on with
high
brightness
Taillights
keep on
Taillights
turn red with
high
brightness
amid brake
operation
I II III IV V
OFF
OFF OFF
OFF
OFF OFF OFF
OFF
OFF
•
•
•
• • •
Control
Mod
Remarks
Throttle
linkage
control
Brake lights are on with
high brightness amid brake
operation
Function
Power on
is off by
default
Before operation, install the battery and connect the system as instructed below.
Danger
Danger
Danger
Danger
Danger
Danger
Danger Only use specified battery (X4 AAA batteries).
Do not open, disassemble, or attempt to repair the battery.
Do not crush/puncture the battery, or short the external contacts.
Do not expose to excessive heat or liquids.
Do not drop the battery or expose to strong shocks or vibrations.
Always store the battery in a cool, dry place.
Do not use the battery if damaged.
Battery Type: AAA
Battery Installation:
1.Open the battery compartment cover.
2.Insert 4 fully-charged AAA batteries into the compartment. Make sure that the battery makes good
contact with the battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2V, the LED on the panel will flash slowly.