Roche Cedex HiRes, Operator'S Manual

Page: 104 / 166

98
Cedex HiRes Analyzer Operator’s Guide
D
D
6.4.2. Specifying Default Measurement Parameters
The logged-in user can determine the preferred default values for certain measurement parameters (Cell Type,
dilution, etc.). The default parameter settings are only valid for this user.
Follow the instructions below to change the default values for certain measurement parameters (see Figure 71):
1
Select User Preferences in the Master Data menu of the Control Center . This will open the User
Preferences window.
2
Select the Measurement tab in the User Preferences window.
3
Manually type in the appropriate default measurement parameters in the Value column. The defaults for the
following parameters can be determined:
CellType,
DefaultCombinedNumber (for the Measurement Statistics Histogram),
MeasurementPrecision,
ReactorID,
SampleInitialDilution,
SampleVolume,
Workarea.
CellDiameterHistogramDividers (sets the intervals to be applied to all cell diameter histograms; note that
the format should be x y z . If the numbers are placed in brackets, such as (x) (y) (z) , the intervals will be
shown in the histogram by default, but not activated.
4
Put a check mark in the check-box of the Save Last column if the last value used for a measurement should
be used as the default for the next measurement.
5
Click on Save to confi rm.
6
Close the window. The new default parameters will apply to new measurements.
■
6.4.3. Specifying Other Default Parameters
Other default parameters can be specifi ed for the Measurement List window, the CTC Views window and the
Audit Trail . Select the following tabs to create or alter default parameters:
Measurement Default Filter : Create or alter default parameters for fi lter settings in the Measurement List
window.
CTC Views Default Filter : Create or alter default parameters for the fi lter settings in the CTC Views window.
Audit Trail Default Filter : Create or alter default parameters for the fi lter settings in the Audit Trail window.
General Functions of the System
User Preferences