R302V Operation Manual
5
B. CONTINUOUS FEED ATTACHMENT ASSEMBLY INSTRUCTIONS
If you are preparing to use the dicing or the
French fry combinations
Dicing
; follow
steps 1, 2, and 3
above, then, align
the blades on the dicing grid with the entry port to
be used (see drawing below). The large indentions
on the outer rim of the grid should fit around the
raised tabs on the continuous feed attachment.
Place the corresponding slicing plate on the dis-
charge plate and rotate until it falls into place.
Secure the slicing plate by screwing it into the
motor shaft using the provided knob. Continue with
step #5 above.
French Fry combinations;
First follow
steps 1, 2,
and 3
above. Then, fit the molded plastic piece of
the combo into the continuous feed attachment with
the blades facing the discharge chute. The large
indentions on the outer rim should fit around the
raised tabs on the continuous feed attachment.
Place the corresponding slicing plate on the dis-
charge plate and rotate until it falls into place.
Secure the slicing plate by screwing it into the
motor shaft using the provided knob. Continue with
step #5 above.
